Mario Andretti
Posted: Fri Nov 13, 2015 10:39 pm
RUBBER RINGS
BULBS
Backbox
Inserts, Flashers, and Feature Lights
General Illumination
Playfield
Inserts, Flashers and Feature Lights
General Illumination
NOTES
1) Pay close attention to the hex post lengths at the pop bumpers, while they appear similar, they are designed specifically for the overlapping plastics.
2) Use a soldering iron to get the posts out of the playfield. They have loctite on them, and will break if forced off. Use the iron on the bottom of the post (where the nut is) and heat it up to loosen the loctite.
BULBS
Backbox
Inserts, Flashers, and Feature Lights
General Illumination
Playfield
Inserts, Flashers and Feature Lights
General Illumination
NOTES
1) Pay close attention to the hex post lengths at the pop bumpers, while they appear similar, they are designed specifically for the overlapping plastics.
2) Use a soldering iron to get the posts out of the playfield. They have loctite on them, and will break if forced off. Use the iron on the bottom of the post (where the nut is) and heat it up to loosen the loctite.